Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Vostro 3401 Service Manual

Reconnecting the battery

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

Reconnect the battery

Steps

  1. Connect the battery cable to the connector on the system board.
  2. Replace the tape covering the battery connector.

Next steps

  1. Install the base cover.
  2. Install the SD card.
  3. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\