Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Vostro 3401 Service Manual

Installing the display assembly

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

NOTE: Ensure that the hinges are opened to the maximum before replacing the display assembly on the palmrest and keyboard assembly.

Install the display assemblyInstall the display assembly

Steps

  1. Align and place the system under the hinges on the display assembly.
  2. Install the four (M2.5x5) screws securing the display assembly in place.
  3. Re-route the display cable and WLAN antenna cables through the routing channels on the palmrest.
  4. Reconnect the display cable to the connector on the system board.

Next steps

  1. Install the WLAN.
  2. Install the base cover.
  3. Install the SD card.
  4. Follow the procedure in after working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\