Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Vostro 3401 Service Manual

Removing the display assembly

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the SD card.
  3. Remove the base cover.
  4. Disconnect the battery cable.
  5. Remove the WLAN.

About this task

Removing the dispplay assemblyRemoving the dispplay assembly

Steps

  1. Disconnect the display cable from the connector on the system board.
  2. Unthread the display cable and WLAN antenna cables from the routing channels.
  3. Open the system to at least 90-degrees and place the system on the edge of a table so that the palm rest is laying flat on the table and the display assembly is over the edge.
  4. Remove the four (M2.5x5) screws securing the display assembly in place.
  5. Remove the display assembly from the system.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\