Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Vostro 3401 Service Manual

Removing the touch pad assembly

Prerequisites

  1. Follow the procedure in before working inside your computer.
  2. Remove the SD card.
  3. Remove the base cover.
  4. Remove the battery.

About this task

Removing the touch pad assembly

Steps

  1. Disconnect the touchpad FFC from the system board.
  2. Peel back the conductive tape from the touchpad module.
  3. Remove the three (M2x2) screws securing the touchpad bracket in place.
  4. Remove the touchpad bracket from the system.
  5. Remove the two (M2x2) screws securing the touchpad module in place.
  6. Remove the touchpad module with touchpad FFC from the system.
  7. Disconnect the touchpad FFC from the touchpad module.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\