Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Vostro 3405 Service Manual

Installing the base cover

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the base cover and provides a visual representation of the installation procedure.

Installing the base cover

Installing the base cover

Installing the base cover

Steps

  1. Connect the battery cable to the connector on the system board.
  2. Place and snap the base cover into place on the palm-rest and keyboard assembly.
  3. Tighten the two captive screws on the base cover.
  4. Replace the seven screws (M2.5x5) that secure the base cover to the palm-rest and keyboard assembly.

Next steps

  1. Install the SD card.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\