Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Vostro 3405 Service Manual

Installing the battery

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the battery and provides a visual representation of the installation procedure.

Installing the battery

Steps

  1. Place the battery on the palm-rest and keyboard assembly.
    NOTE When installing the battery into the system, insert the tab at the bottom left corner of the battery into the hook on the bottom side of the palm rest. Installing the battery
  2. Align the screw holes on the battery to the screw holes on the palm-rest and keyboard assembly.
  3. Replace the three screws (M2x3) that secure the battery to the palm-rest and keyboard assembly.
  4. Connect the battery cable to the connector on the system board.

Next steps

  1. Install the base cover.
  2. Install the SD card.
  3. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\