Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Vostro 3405 Service Manual

Installing the display panel

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the display panel and provides a visual representation of the installation procedure.

Installing the display panel

Installing the display panel

Installing the display panel

Steps

  1. Place the display panel and display assembly on a clean and flat surface.
  2. Connect the display cable to the connector on the display panel and close the latch.
  3. Adhere the tape that secures the display-cable connector latch to the display panel.
  4. Lift and rotate the display panel, then place the display panel on the display assembly.
  5. Align the screw holes on the display panel to the screw holes on the display assembly.
  6. Replace the six screws (M2.5x2.5) that secure the display panel to the display assembly.
  7. Place the display bezel on the display assembly.
  8. Align the tabs on the display bezel to the slots on the display assembly.
  9. Press down on the display bezel and snap the display bezel in place.

Next steps

  1. Install the display bezel.
  2. Install the display assembly.
  3. Install the wireless card.
  4. Install the battery.
  5. Install the base cover.
  6. Install the SD card.
  7. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\