Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Vostro 3405 Service Manual

Installing the M.2 2280 solid-state drive

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

NOTE This procedure applies if you are installing a M.2 2280 solid-state drive.
NOTE The M.2 card installed on your computer will depend on the configuration ordered. Supported card configurations on the M.2 card slot:
  • M.2 2230 solid-state drive + 2230 mounting bracket
  • M.2 2280 solid-state drive

The following images indicate the location of the M.2 2280 solid-state drive and provides a visual representation of the installation procedure.

Installing the M.2 2280 solid-state drive

Steps

  1. Align the notch on the M.2 2280 solid-state drive with the tab on the M.2 card slot on the system board.
  2. Slide the M.2 2280 solid-state drive into the M.2 card slot on the system board.
  3. Place the M.2 thermal shield on the M.2 2280 solid-state drive.
  4. Align the screw holes on the M.2 thermal shield with the screw holes on the palm-rest and keyboard assembly.
  5. Replace the single (M2x2.2) screw and tighten the single captive screw that secures the M.2 thermal shield to the palm-rest and keyboard assembly.

Next steps

  1. Reconnect the battery.
  2. Install the base cover.
  3. Install the SD card.
  4. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\