Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Vostro 3405 Service Manual

Installing the power button

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the power-button with optional fingerprint reader and provides a visual representation of the installation procedure.

Installing the power button

Steps

  1. Using the alignment posts, place the power-button into its slot on the palm-rest and keyboard assembly.
  2. Replace the two screws (M2x2) that secure the power-button to the palm-rest and keyboard assembly.
  3. Connect the power-button cable to the fingerprint-reader board and close the latch, if applicable.
  4. Adhere the tape that secures the power-button cable to the palm-rest and keyboard assembly, if applicable.

Next steps

  1. Install the IO board.
  2. Install the battery.
  3. Install the base cover.
  4. Install the SD card.
  5. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\