Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Vostro 3405 Service Manual

Installing the speakers

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following images indicate the location of the speakers and provides a visual representation of the installation procedure.

Installing the speakers

Steps

  1. Using the alignment posts, place the speakers on the palm-rest and keyboard assembly.
    NOTE Ensure that the alignment posts are threaded through the rubber grommets on the speaker.
  2. Route the speaker cable through the routing guides on the palm-rest and keyboard assembly.
  3. Connect the speaker cable to the system board.

Next steps

  1. Install the M.2 2230 solid-state drive.
  2. Install the M.2 2280 solid-state drive.
  3. Reconnect the battery.
  4. Install the base cover.
  5. Install the SD card.
  6. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\