Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

Dell Vostro 3583 Service Manual

Removing the display assembly

Prerequisites

  1. Follow the procedure in before working inside your computer
  2. Remove the SD memory card
  3. Remove the base cover
  4. Disconnect the battery cable from the connector on the system board
  5. Remove the WLAN

Steps

  1. Open the latch and disconnect the display cable from the system board [1].
  2. Unroute the display cable from the routing guides on the palmrest and keyboard assembly [2].
  3. Peel off the tape securing the wireless antenna from the system board [3].
    Image: Unrouting the display cable
  4. Remove the five (M2.5x5) screws that secure the left and right hinges to the system board, and palmrest and keyboard assembly [1].
  5. Lift the palmrest and keyboard assembly at an angle [2].
    Image: Removing the four screws of left and right hinges
  6. Lift the hinges. Remove the palmrest and keyboard assembly off the display assembly [1, 2]
    Image: Slide and remove the display assembly.
  7. After performing all the preceding steps, you are left with display assembly.
    Image: Removing the display assembly

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\