- Notes, cautions, and warnings
- Working on your computer
- Major components of your system
- Technology and components
- Disassembly and reassembly
- System setup
- Troubleshooting
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Power-Supply Unit Built-in Self-Test
- Real-Time Clock (RTC Reset)
- System diagnostic lights
- Diagnostic error messages
- System error messages
- Recovering the operating system
- Updating the BIOS using the USB drive in Windows
- Updating the BIOS in Windows
- Backup media and recovery options
- Wi-Fi power cycle
- Drain residual flea power (perform hard reset)
- Getting help and contacting Dell Technologies
Vostro 3681 Service Manual
Removing the 2230 solid-state drive
Prerequisites
- Follow the procedure in Before working inside your computer.
- Remove the side cover.
- Remove the HDD/ODD bracket.
About this task
The following images indicate the location of the 2230 solid-state drive and provides a visual representation of the removal procedure.
Steps
- Remove the screw (M2x3) that secures the 2230 solid-state drive to the system board.
- Slide and lift the solid-state drive from the M.2 card slot on the system board.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\