Dell Thunderbolt Dock WD22TB4 User Guide

PDF

Replacing the USB Type-C cable module

Prerequisites

The Dell Thunderbolt Dock - WD22TB4 ships with a serviceable cable module. The USB Type-C cable module on the docking station can be removed and replaced by following these steps:

Steps

  1. Turn over the docking station.
    Turning over the dock
  2. Remove the two (M2.5 x 5) screws from the bottom plate of the docking station.
    Removing the two M2.5 x 5 screws
  3. Using a plastic scribe, gently pull the cable module away from the docking station.
    Gently pull the cable module away.
  4. Gently wiggle and remove the USB Type-C cable module from its connector on the docking station.
    Lift and remove the USB Type-C cable module
  5. Take the replacement cable module out of its packaging.
    Taking the replacement cable out of package
  6. Align and place the cable module on to the docking station.
    Placing the cable module on to the dock
  7. Slide and push the cable module to connect the cable module to the connectors on the docking station.
    Connecting the cable module to the connectors on the dock
  8. Replace the two (M2.5 x 5) screws to the bottom plate of the docking station.
    Replacing the two (M2.5 x 5) screws
  9. Turn the docking station over.
    Turning the dock

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\