Dell Wyse 3040 Thin Client User Guide

PDF

Configuring the broker setup on Dell Wyse ThinOS

To configure the Broker setup:
  1. From the desktop menu, click System Setup, and then click Remote Connections.
    The Remote Connections dialog box is displayed.

    Remote connections

  2. Select Broker type from the drop-down list.
    1. If you select None from the list, click either of the following connection protocols:
    2. If you select the Citrix Xen, use the following guidelines:
      • Select the check box to enable the StoreFront style.
      • Broker Server— Enter the IP address of the Broker Server.

      • Select the check box to enable automatic reconnection at logon.
        NOTE If you enable the automatic reconnection, you are able to select from the reconnection options. Click either of the options where you can connect to the disconnected sessions only or connect to both active and disconnected sessions.
      • Select the check box to enable automatic reconnection from the button menu.

        NOTE If you enable the automatic reconnection, you are able to select from the reconnection options. Click either of the options where you can connect to the disconnected sessions only or connect to both active and disconnected sessions.
      • Account Self-service Server— Enter the IP address of the account self-service server.

      • XenApp — Use this option, if you want to set default settings to XenApp.

      • XenDesktop— Use this option, if you want to set default settings to XenDesktop.

    3. If you select the VMware View, use the following guidelines:
      • Broker Server— Enter the IP address of the Broker server.

      • Security Mode

        — Use this option to select the Security Mode. The available options are Warn on View default, Full security, and No security.
    4. If you select the Microsoft, enter the IP address of the broker server in the Broker Server box, and then click OK to save the settings.
    5. If you select Dell vWorkspace, use the following guidelines:
      • Broker Server— Enter the IP address of the Broker Server.

      • Select the check box to enable vWorkspace Gateway.

      • vWorkspace Gateway— Enter the IP address of the vWorkspace gateway.

    6. If you select Other, you must enter the IP address of the broker server in the Broker Server box.
  3. Click OK to save the settings.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\