Dell Wyse ThinOS 9.1.3129, 9.1.3112, 9.1.2101, and 9.1.1131 Administrator’s Guide

PDF

Configure Citrix ADC using CensorNet MFA authentication

Prerequisites

SMS PASSCODE is re-branded as CensorNet MFA. You can configure the Citrix ADC (formerly NetScaler) to use a One Time Passcode/Password (OTP) in the form of a personal identification number (PIN) or passcode. To obtain this one-time password, you must install CensorNet app on your mobile. After you enter the passcode or PIN, the authentication server invalidates the one-time password. You cannot enter the same PIN or password again. For more information about configuring one-time passcode, see the Citrix documentation.
Prerequisites
  • Citrix ADC (formerly NetScaler) v12.0 and later is installed on your client.
  • SMS PASSCODE v9.0 SP1 or later is installed and configured in your network.
  • Remote Authentication Dial-In User Service (RADIUS) authentication policy is configured and bind to the Citrix ADC server.
  • CensorNet app is installed and configured on your mobile device.

About this task

To use the one-time passcode on ThinOS, do the following:

Steps

  1. Log in to ThinOS and connect to the ADC URL.
  2. Enter your credentials, and press Enter.
    The PASSCODE dialog box is displayed. You will receive a push notification from the CensorNet App on your phone with the code.
  3. Click OK.
    If the authentication is successful, you are logged into the Citrix session.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\