Dell Wyse ThinOS 9.1.3129, 9.1.3112, 9.1.2101, and 9.1.1131 Administrator’s Guide

PDF

Configure the Wacom tablet mode

Prerequisites

Ensure that you have enabled the Wacom tablet feature in the session menu. See, Enable Wacom tablet using the session menu.

Steps

  1. On the ThinOS client, start Admin Policy Tool or go to the ThinOS 9.x policy settings on Wyse Management Suite.
  2. On the Advanced tab, expand Session Settings, and click PCoIP Session Settings.
  3. From the Wacom Tablet Configurations drop-down list, select either of the following modes:
    • Locally terminated—Enables the peripheral data to be processed locally at the thin client. Locally terminated tablets have greatly improved responsiveness, and tolerate network with 25 milliseconds and higher latency.
    • Bridged—Enables the peripheral data to be sent to the desktop for processing. Bridged Wacom tablets are supported only in low-latency environments. Reduced responsiveness is observed in network environments with greater than 25-millisecond latency.
  4. Click Save & Publish.

Next steps

  1. Connect the tablet to the thin client.
  2. Open the Wacom Desktop Center application in the session.
  3. Verify the tablet connection.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\