Dell Wyse ThinOS 9.1.3129, 9.1.3112, 9.1.2101, and 9.1.1131 Administrator’s Guide

Configuring PCoIP connections using Teradici Remote Workstation card

ThinOS enables you to directly configure the PCoIP connection using either the TERA2240 Remote Workstation Card or TERA2220 Remote Workstation Card. This feature is supported only on PCoIP-enabled thin clients. This feature only works with the direct PCoIP connection.

1. On ThinOS desktop, go to Connect Manager.
2. Click New, and then click PCoIP.
3. In the Connection Settings (PCoIP) dialog box, do the following:
   1. Enter the description for the PCoIP connection.
   2. Enter the IP address of the remote host card.
   3. From the Display Resolution drop-down list, select a display resolution for the PCoIP connection.
      TERA2220 supports a single display with 2560 x 1600 resolution or two displays with 1920 x 1080 resolution. TERA2240 supports two displays with 2560 x 1600 resolution, four displays with 1920 x 1080 resolution, or a single display with 3840 x 2160 resolution.
   4. Select either the Window mode or Full screen to set the initial view of the session.
   5. If you want to automatically connect to the session after you restart the thin client, select the Auto-connect on start-up check box.
   6. Select the Re-connect after disconnect check box if you want to automatically reconnect to a session after the session is disconnected. If you select this option, enter the wait interval in the Delay before re-connecting box. The default is 20 seconds.
4. Click OK to save your settings.
   NOTE:You can still hear the sound after you mute audio in the Remote Workstation Card session. The behavior is related to Teradici and not ThinOS.

   For information about the Teradici host cards, see the Host Card documentation at www.teradici.com.