Dell Wyse ThinOS 9.1.3129, 9.1.3112, 9.1.2101, and 9.1.1131 Administrator’s Guide

PDF

Log in to Citrix ADC using the passcode

Prerequisites

  • Ensure that you are using Citrix ADC (formerly NetScaler) 12.0 build 51.24 and later versions.
  • Ensure that you have registered your device with Citrix ADC. For a detailed procedure on how to register your device with Citrix ADC, see the Native OTP support for authentication article at docs.citrix.com.

About this task

This section describes how to log in to Citrix ADC using the OTP.

Steps

  1. From the desktop menu, click System setup > Remote Connections.
    The Remote Connections dialog box is displayed.
  2. Click the Broker Setup tab and select Citrix Virtual Apps and Desktops from the Broker Type drop-down list.
  3. Enter the IP address of the Citrix ADC FQDN server in the Broker Server field.
    You can configure other options if required.
  4. Click OK.
    The NetScaler login window is displayed.
  5. Launch the Google Authenticator application on your phone and get the passcode.
  6. In the Citrix ADC login window, enter the passcode and click OK.
    If the authentication is successful, you are logged into Citrix ADC.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\