Dell Wyse Management Suite Version 5.0 Administrator Guide

PDF

Validate the enrollment of a device

You can enable Enrollment Validation to enable administrators to control the manual and auto registration of thin clients to a group. You can filter the devices in Pending Validation state by clicking the Pending count in the Dashboard page or by selecting the Enrollment Validation Pending in the Status drop-down list in the Devices page.

Prerequisites

  • You must enable the Enrollment Validation option when you install Wyse Management Suite or in the Portal Administration page.
  • The device must be in Enrollment Pending state.

Steps

  1. Select the check box of the device that you want to validate.
  2. Click the Validate Enrollment option.
    An Alert window is displayed.
  3. Click Send Command.
    The device moves to the wanted group, and the device is registered.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\