Dell Wyse Management Suite Version 3.1 Administrator's Guide

CIFS use case scenarios

The following use cases are supported in Wyse Management Suite:

• When you select Wyse Management Suite as Setup Type while installing Wyse Management Suite private cloud.
  • CIFS configuration page is displayed. This page is required as we need to configure the shared folder.
    NOTE: The Configure CIFS User Credentials option is disabled by default.
• When you select Teradici EMSDK as Setup Type while installing Wyse Management Suite private cloud.
  • For CIFS credentials, you can use an existing account or create a new one.
• When you select both Wyse Management Suite and Teradici EMSDK as Setup Type while installing Wyse Management Suite private cloud.
  • CIFS configuration page is displayed. This page is required as we need to configure the shared folder.
    NOTE: The Configure CIFS User Credentials option is disabled by default.
  • For CIFS credentials, you can use an existing account or create a new one.
• When you install only EMSDK on a system which already has the EMSDK service installed.
  • If Teradici EMSDK is selected then a warning message is displayed when you click Next from the Setup Type page. The message is The installer has detected that the Teradici EMSDK is already installed. The EMSDK will be updated if required. No port number is required.
    • If Configure CIFS User Credentials option is selected (By default)
      1. Stop the service.
      2. Update the EMSDK service.
      3. Restart the service. It operates under the same pre-configured user.
    • If Configure CIFS User Credentials option is selected with Use an existing useroption.
      1. Stop the service.
      2. Update the EMSDK service.
      3. Update the service log on user to the one selected.
      4. Restart the service. It operates under the same pre-configured user.
    • If Configure CIFS User Credentials option is selected with Create a New User option.
      1. Stop the service.
      2. Update the EMSDK service.
      3. Update the service log on user to the newly created user.
      4. Restart the service. It operates under the same pre-configured user.

• When you install both Wyse Management Suite and Teradici EMSDK on a system that has already the EMSDK service installed.
  • Same as When you install only EMSDK on a system which already has the EMSDK service installed except that the Configure CIFS User Credentials option is selected by default and greyed out. You must enter CIFS credentials.