XPS 13 7390 2-in-1 Service Manual

Assigning a system setup password

Prerequisites

You can assign a new System or Admin Password only when the status is in Not Set.

About this task

To enter the system setup, press F2 immediately after a power-on or reboot.

Steps

  1. In the System BIOS or System Setup screen, select Security and press Enter.
    The Security screen is displayed.
  2. Select System/Admin Password and create a password in the Enter the new password field.
    Use the following guidelines to assign the system password:
    • A password can have up to 32 characters.
    • The password can contain the numbers 0 through 9.
    • Only lower case letters are valid, upper case letters are not allowed.
    • Only the following special characters are allowed: space, (”), (+), (,), (-), (.), (/), (;), ([), (\), (]), (`).
  3. Type the system password that you entered earlier in the Confirm new password field and click OK.
  4. Press Esc and a message prompts you to save the changes.
  5. Press Y to save the changes.
    The computer reboots.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\