The following images indicate the location of keyboard assembly and provide a visual representation of the removal procedure.
Steps
Peel the fingerprint reader cable from the keyboard.
Remove the speaker cable from the routing guides on the left keyboard bracket.
Loosen the captive screw that secures the left keyboard bracket to the palm-rest assembly.
Using a plastic scribe, pry the left keyboard bracket off the palm-rest assembly.
Loosen the captive screw that secures the right keyboard bracket to the palm-rest assembly.
Using a plastic scribe, pry the right keyboard bracket off the palm-rest assembly.
Disconnect the keyboard cable and keyboard backlight cable from the keyboard controller board.
Peel the keyboard controller board cable from the keyboard.
Remove the 38 screws (M1.2x1.4) and ten screws (M1.2x1.6) that secure the keyboard to the palm-rest assembly.
NOTE: Peel off the three copper foil from the palm-rest assembly, and then peel off the two conductive tapes on the keyboard assembly to separate the keyboard assembly and the palm-rest assembly.
Lift the keyboard off the palm-rest assembly.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\