XPS 13 9305 Service Manual

PDF

Procedure

  1. Align the screw holes on the heat sink with the screw holes on the system board.
  2. Replace the four screws (M2x3) that secure the heat sink to the system board in sequential order (as indicated on the heat sink).
    Image: Replacing the heat sink

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\