XPS 13 9305 Service Manual

PDF

Procedure

  1. Remove the screw (M1.6x3) that secures the wireless antenna and camera-cable bracket to the system board.
  2. Lift the wireless antenna and camera-cable bracket from the system board.
  3. Disconnect and lift the wireless antenna and camera-cable bracket from the system board, peeling off the tape securing the camera cable to the heat-sink and fan assembly.
    Image: Removing the heat-sink assembly
  4. Disconnect the left fan cable from the system board.
  5. Disconnect the right fan cable from the system board.
  6. In reverse-sequential order (as indicated on the heat sink), remove the four screws (M2x3) that secure the heat-sink and fan assembly to the system board.
  7. Remove the two screws (M1.6x3) that secure the heat-sink and fan assembly to the system board.
  8. Lift the heat-sink and fan assembly along with the left-fan and the right-fan cable off the system board.
    Image: Removing the heat-sink assembly

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\