XPS 13 9305 Service Manual

PDF

Procedure

  1. Place the headset port in its slot on the palm-rest assembly.
  2. Replace the screw (M1.6x3) that secures the headset port to the palm-rest assembly
  3. Reconnect the headset-port cable to the system board.
    Image: Replacing the headset port
  4. Using the alignment posts, press the right display hinge down to the palm-rest assembly aligning the screw holes on the display hinge to the screw holes on the palm-rest assembly.
  5. Replace the two screws (M2.5x4) that secure the left hinge to the palm-rest assembly.
    Image: Replacing the headset port

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\