XPS 13 9305 Service Manual

PDF

Procedure

  1. Remove the screw (M1.6x3) that secures the wireless antenna and camera-cable bracket to the system board.
  2. Lift the wireless antenna and camera-cable bracket from the system board.
  3. Disconnect and lift the camera cable from the system board, peeling off the tape securing the camera cable to the fans.
    Image: Removing the fans
  4. Disconnect the right-fan cable from the system board.
  5. Disconnect the left-fan cable from the system board.
  6. Remove the two screws (M1.6x3) that secure the left and the right fan to the system board.
  7. Lift the left and the right fans along with their cables off the system board.
    Image: Removing the fans

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\