Skip to main content
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Enjoy members-only rewards and discounts
  • Create and access a list of your products

XPS 14 9440 Owner's Manual

Removing the M.2 2280 solid-state drive (SSD)

CAUTION:The information in this removal section is intended for authorized service technicians only.

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the base cover.

About this task

NOTE:Depending on the configuration ordered, your computer may support an M.2 2280 SSD or an M.2 2280 SSD.
NOTE:This procedure applies only to computers shipped with an M.2 2280 SSD.
The following image indicates the location of the M.2 2280 SSD and provides a visual representation of the removal procedure.
Figure 1. Removing the M.2 2280 solid-state drive
Image: Removing the M.2 2280 solid-state drive

Steps

  1. Remove the screw (M2x2.5) that secures the M.2 SSD thermal shield to the system board.
  2. Slide and remove the M.2 SSD thermal shield off the system board.
  3. Lift and slide the M.2 2280 SSD out of the SSD slot.
    NOTE:XPS 14 9440 consists of a thermal pad adhered to the system board under the M.2 SSD. The thermal pad may get separated from the system board or get adhered to the SSD. Adhere the thermal pad to the SSD compartment if it is detached from the system board during the removal process.
    Figure 2. M.2 SSD thermal pad
    Image: M.2 SSD thermal pad

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\