XPS 15 Service Manual

Procedure

  1. In sequential order (indicated on the heat sink), remove the four screws (M2x3) that secure the heat sink to the system board.
    NOTE: The fourth screw is covered by tape. Remove this screw before lifting the heat sink from the system board.
    NOTE: For configurations shipped with integrated graphics, the heat sink has only three screws (M2x3).
  2. Lift the heat sink off the system board.
    Figure 1. Removing the heat sink
    Image: Removing the heat-sink assembly
    1. heat sink

    2. screws (5)


Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\