XPS 8960 Service Manual

PDF

Installing the front-chassis fan

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

The following image(s) indicate the location of the front-chassis fan and provides a visual representation of the installation procedure.

Installing the chassis fan

Steps

  1. Slide the tabs on the front-chassis fan into the slots on the chassis and rotate the rear-chassis fan inwards.
  2. Press the front-chassis fan against the chassis to snap the chassis fan in place.
  3. Connect the front-chassis fan cable to the system board.
  4. Replace the screw (M3x5) that secures the front-chassis fan to the chassis.
  5. Place the computer in an upright position.

Next steps

  1. Install the left-side cover.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\