XPS 8960 Service Manual
Installing the processor fan and heat-sink assembly (125 W, air cooling)
Prerequisites
About this task
NOTE:If either the processor or the fan and heat-sink assembly is replaced, use the thermal grease that is provided in the kit to ensure that thermal conductivity is achieved.
NOTE:This procedure only applies for computers that are shipped with a 125 W processor.
NOTE:This procedure also includes the specific back-chassis fan that is installed on your computer with the use of the processor fan and heat-sink assembly (125 W, air cooling)
The following images indicate the location of the processor fan and heat-sink assembly (125 W, air cooling) and provide a visual representation of the installation procedure.
Steps
- Place the heat sink on the system board and align the captive screws to the screw holes on the system board.
- In reverse sequential order (4>3>2>1), tighten the four captive screws that secure the heat stink to the system board.
- Connect the processor fan and heat-sink assembly fan cable to the system board.
- Place the computer in an upright position.
Next steps
- Install the left-side cover.
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\