XPS 8960 Service Manual

PDF

Installing the SMA cable

Prerequisites

If you are replacing a component, remove the existing component before performing the installation procedure.

About this task

The following images indicate the location of the SMA cable and provide a visual representation of the removal procedure.

Installing the SMA cable

Steps

  1. Align and place the SMA cable connector on the chassis.
  2. Route the SMA cable under the PCIe x16 slot.
  3. Insert the SMA cable to the securing clip on the system board.
  4. Route the SMA cable assembly through the slot on the rear I/O.
  5. Replace the washer and nuts that secure the SMA cable connector to the chassis.

Next steps

  1. Install the wireless card.
  2. Install the single-graphics card.
  3. Install the left-side cover.
  4. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\