XPS 8960 Service Manual

PDF

Removing the 2280 solid-state drive

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the left-side cover.

About this task

NOTE:Depending on the configuration ordered, your computer may have up to two M.2 2230/2280 solid-state drives installed in the two M.2 solid-state drive slots on the system board.

The following image(s) indicate the location of the 2280 solid-state drive and provides a visual representation of the removal procedure.

Removing the 2280 solid-state drive

Steps

  1. Place the computer on its side with the left side facing up.
  2. Remove the screw (M2x3) that secures the 2280 solid-state drive to the system board.
  3. Slide and lift the 2280 solid-state drive from the M.2 card slot on the system board.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\