XPS 8960 Service Manual

PDF

Removing the SMA cable

Prerequisites

  1. Follow the procedure in Before working inside your computer.
  2. Remove the left-side cover.
  3. Remove the single-graphics card.
  4. Remove the wireless card.

About this task

The following images indicate the location of an SMA cable and provide a visual representation of the removal procedure.
NOTE:The SMA cable is available in computers that have a 500 MT/s configuration.
Removing the SMA cable

Steps

  1. Remove the washer and nuts that secure the SMA cable connector to the chassis.
  2. Route the SMA cable assembly through the slot on the rear I/O.
  3. Remove the SMA cable from the securing clip on the system board.
  4. Remove the SMA cable routing from the PCIe x16 slot.
  5. Lift the SMA cable connector off the chassis.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\