XPS 14 DA14260 Service Manual

PDF

Installing the M.2 2280 solid-state drive (SSD)

Prerequisites

If you are replacing a component, remove the existing component before performing the installation process.

About this task

NOTE:Depending on the configuration ordered, your computer may support an M.2 2230 SSD or an M.2 2280 SSD.
NOTE:This task applies only to computers shipped with an M.2 2280 SSD.

The following video provides an overview of this task.

Image: Video icon

The following image indicates the location of the M.2 2280 SSD and provides a visual representation of the installation procedure.

Figure 1. Install the M.2 2280 solid-state drive
Installing the M.2 2280 solid-state drive

Steps

  1. Align the notch on the M.2 2280 SSD with the tab on the SSD slot, then gently slide the SSD into the slot.
    CAUTION:When installing the SSD, be careful not to damage or dislodge the thermal pad on the system board.
  2. Place the M.2 SSD thermal shield onto the M.2280 SSD as shown, ensuring the screw holes are aligned with the system board.
  3. Replace the two screws (M2x3) that secure the M.2 SSD thermal shield to the system board.

Next steps

  1. Install the Palm-rest and keyboard assembly.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\