XPS 14 DA14260 Service Manual

PDF

Installing the wireless-module shield

CAUTION: The information in this removal section is intended for authorized service technicians only.

Prerequisites

About this task

The following video provides an overview of this task.

Image: Video icon

The following image indicates the location of the wireless-module shield and provides a visual representation of the installation procedure.

Figure 1. Installing the wireless-module shield
Installing the wireless-module shield

Steps

  1. If disconnected, connect the antenna cable with the white sleeve to connector on the wireless module (indicated by the black triangle).
  2. If disconnected, connect the antenna cable with the black label to the connector on the wireless module (indicated by the white triangle).
  3. Align the screw hole on the wireless-module shield with the screw hole on the system board.
  4. Replace the screw (M2x3) that secures the wireless-module shield to the system board.

Next steps

  1. Install the Palm-rest and keyboard assembly.
  2. Follow the procedure in After working inside your computer.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\