After installing the Replay Manager Verification Service
on the server, configure the Replay Manager to use the Verification
Service for backups and restores of Microsoft Exchange Servers.
Start the Replay Manager Explorer, and connect
to the Exchange server for which you want to verify backup and restore
operations.
Click Configure, and click the
Exchange Verification tab.
Specify the following:
Verification Server Host Name: Enter
the host name or IP address of the server on which the Replay Manager
Verification Service is installed.
Verification Server Service Port: Enter
the service port for communications between Replay Manager and the
Replay Manager Verification Service. Unless a conflict would result,
use the default service port value of 29176.
Lower LUN Limit and Upper
LUN Limit: Enter a range of LUNs to use for mapping volumes
to the Verification Service host. If no range is specified, Replay
Manager uses all available LUNs; Windows allows an upper limit of
254 LUNs.
Storage Center Server Definition: Select
the Verification Server Host Name for each Storage Center.
Click Test Server. Replay Manager
attempts to locate and validate the host name. When successful,
a green indicator button appears with Verification server
successfully tested.
Click Save.
Data is not available for the Topic
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\