- Notes, cautions, and warnings
- Copyright
- Introduction
- Getting started: Basics
- Configuring thin client settings locally
- Configuring
Connections locally
- Configuring and managing the browser connections
- Configuring and managing Citrix connections
- Configuring and managing VMware connections
- Configuring and managing RDP connections
- Configuring and managing the custom connections
- Configuring and managing the SSH connections
- Configuring and managing the VNC viewer connections
- Configuring and managing the Ericom PowerTerm connections
- Security settings
- Additional management configurations
- Viewing XTerm
- Imaging solutions
- Central Configuration: Automating Updates and Configurations
- DHCP options tags
- Mixed Environment Imaging – An Enhanced Method of Upgrading
Dell Wyse ThinLinux 1.0.3 Administrator’s Guide
Downgrading and force imaging
Image downgrading does not take place unless INI parameter , Update.AllowDowngrade=yes is specified or enabled through GUI. The imaging process does not take place if the checksum of image file is the same as that of base image, unless force imaging is enabled through GUI. The setting of forcing is reset after imaging. The force imaging of the same version of image is not supported by INI because it causes a non-stop imaging of the same image when INI exists.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\