- Notes, cautions, and warnings
- Working on your computer
- Removing and installing components
- Base cover
- Battery
- Speaker
- Hard drive
- Coin-cell battery
- Solid State Drive
- Intel Optane card—optional
- WLAN card
- Memory module
- System fan
- Heat sink
- Input Output board
- Power button
- System board
- Touchpad
- Display assembly
- Display bezel
- Camera
- Display panel
- Display hinges
- DC-in
- Keyboard lattice and Keyboard
- Palm rest
- eDP cable
- Display back cover assembly
- Technology and components
- System specifications
- System setup
- Software
- Troubleshooting
- Contacting Dell
Dell Vostro 5471 Owners's Manual
Installing the power button
- Place the power button to its slot in the system.
- Replace the screws to secure the power button to the system.
- Connect the power cable to the connector in the fingerprint board.
- Close the display hinge and secure it with the two M2.5 x 4 screws to the system.
- Install the:
- Follow the procedure in After working inside your computer.
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\