Omitir para ir al contenido principal

Dell Precision Tower 5810/7810/7910/1700MT/1700SFF/3620MT and Rack 7910 Thunderbolt Add-In-Cards Setup Guide

PDF

Setting up the Thunderbolt Add-In-Card

This section describes in brief on how to install the thunderbolt add-in-cards on a Dell Precision Tower 5810, 7810, 7910, Rack 7910, T1700 MT, T1700 SFF and 3620 MT.

Pre-requisite actions before setting up a Thunderbolt card:

  1. To utilize a Thunderbolt Add-In-Card (AIC) make sure you have a compatible Thunderbolt system board. Figure displaying connecting display port to DisplayPort cable.
  2. Install Thunderbolt software before installing the Add-In-Card (AIC).
NOTE: Thunderbolt card supports windows operating system only. Linux operating system is not supported.

To setup a Thunderbolt Add-In-Card

  1. Connect the GPIO cable to the GPIO header on the system board.
    NOTE: There is a 5-Pin keyed GPIO cable, one end goes to the card, and the other end goes to the GPIO header on the system board.
    • For Precision Tower 7910: the Thunderbolt AIC is placed in CPU1 slot 3
    • For Precision Tower 5810/T7810: the Thunderbolt AIC is placed in CPU1 slot 5
    • For Precision Rack 7910: the Thunderbolt AIC NOT supported
    • For Precision T1700 MT: the Thunderbolt AIC is placed in slot 4
    • For Precision T1700 SFF: the Thunderbolt AIC is placed in slot 1
    • For Precision T3620 MT: the Thunderbolt add in card (AIC) is placed in slot 3
    Figure displaying GPIO cable to the GPIO header
  2. Connect the display port to DisplayPort cable. Figure displaying connecting display port to DisplayPort cable.

Califique este contenido

Preciso
Útil
Fácil de comprender
¿Este artículo fue útil?
0/3000 characters
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Proporcione calificaciones (1 a 5 estrellas).
  Seleccione si el artículo fue útil o no.
  Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"