- Notes, cautions, and warnings
- About this document
- PowerEdge C6615 system configurations and features
- System configurations - rear view for PowerEdge C6615
- System configurations - inside view for PowerEdge C6615
- Network ports indicator codes
- Sled to hard drive mapping
- C6600 chassis options and drive enumerations
- Locating the Express Service Code and Service Tag
- Accessing system information by using QR code
- System information label
- Technical specifications
- Sled dimensions
- System weight
- Processor specifications
- PSU specifications
- Supported operating systems
- System battery specifications
- Expansion card riser specifications
- Memory specifications
- Storage controller specifications
- Drives
- Ports and connectors specifications
- Video specifications
- Environmental specifications
- Initial system setup and configuration
- Pre-operating system management applications
- System Setup
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Recommended tools
- C6615 sled
- Air shroud
- Support bracket
- Expansion cards and expansion card risers
- M.2 SSD module
- System memory
- Processor and heat sink module
- Power Interposer Board
- Optional OCP NIC card
- System battery
- System board
- Trusted Platform Module
- Minimum to POST and system management configuration validation
- Upgrade Kits
- Jumpers and connectors
- Using system diagnostics
- Getting help
- Documentation resources
Dell PowerEdge C6615 Installation and Service Manual
About this document
This document provides an overview about the system, information about installing and replacing components, diagnostic tools, and guidelines to be followed while installing certain components.
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Proporcione calificaciones (1 a 5 estrellas).
Seleccione si el artículo fue útil o no.
Los comentarios no pueden contener estos caracteres especiales: <>"(", ")", "\"