- Notes, cautions, and warnings
- Working on your computer
- Disassembly and reassembly
- M.2 Intel Optane Memory Module 16 GB
- Technology and components
- BIOS setup
- Software
- Troubleshooting your computer
- Power-Supply Unit Built-in Self-Test
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Diagnostic and Power LED codes
- Power LED issue
- Diagnostic error messages
- Verifying system memory
- System error messages
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Backup media and recovery options
- Wi-Fi power cycle
- Technical specifications
- Processor specifications
- Memory specifications
- Video specifications
- Audio specifications
- Communication specifications
- Storage specifications
- Ports and connectors specifications
- Power supply specifications
- Physical dimension specifications
- System board layout
- Controls and lights specifications
- Environmental specifications
- Getting help and contacting Dell
OptiPlex 3050 Tower Owner's Manual
Entering BIOS setup program
Steps
- Turn on your computer.
-
Press F2 immediately to enter the BIOS setup program.
NOTE:If you wait too long and the operating system logo appears, continue to wait until you see the desktop. Then, turn off your computer and try again.
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez indiquer si l’article a été utile ou non.
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\