Dell PowerEdge RAID Controller S140 User’s Guide

PDF

Cabling the drives for S140

CAUTION:La plupart des réparations ne peuvent être effectuées que par un technicien de maintenance agréé. N'effectuez que les opérations de dépannage et les petites réparations autorisées par la documentation de votre produit et suivez les instructions fournies en ligne ou par téléphone par l'équipe de maintenance et d'assistance technique. Tout dommage provoqué par une réparation non autorisée par Dell est exclu de votre garantie. Consultez et respectez les consignes de sécurité fournies avec votre produit.

NOTE: For information on removing and reinstalling system parts, see the PowerEdge systems owner’s manuals at dell.com/poweredgemanuals.

This section provides details about the cabling information for the integrated PERC S140 controller.

NOTE: For information about cabling SATA and NVMe PCIe SSDs for S140, see your system owner's manual at dell.com/poweredgemanuals.

Turn off the system, including any attached peripherals, and disconnect the system from the electrical outlet and peripherals.
NOTE: It is recommended that you always use a static mat and static strap while working on components in the interior of the system.
Remove the system cover.
Locate the connectors J_SATA A and J_SATA B on the system board.
Connect the J_SATA A and J_SATA B connectors on the AHCI devices to the corresponding cable connectors on the backplane using the SATA cables.
NOTE:The first AHCI device provides connectivity to the drives available on port 0–5 and the second AHCI device provides connectivity to the drives available on port 6–13. For information about disk connectivity for AHCI devices, see Disk connectivity for AHCI devices.
Install the system cover.
Turn on the system.
Figure 1. Cabling the S140 controller
1. backplane
2. system board
3. connector on the first AHCI device (J_SATA A)
4. connector on the second AHCI device (J_SATA B)