- Notes, cautions, and warnings
- Working inside your computer
- Removing and installing components
- Recommended tools
- Screw List
- Major components of your system
- MicroSD-card
- SIM card tray
- Base cover
- Battery cable
- Memory module
- M.2 solid-state drive conversion bracket
- M.2 solid-state drive thermal plate
- M.2 solid-state drive
- Hard-disk drive
- WLAN card
- WWAN card
- System fan
- Battery
- I/O cable
- Display assembly
- Heatsink assembly
- Power adapter port
- Coin-cell battery
- USB cable
- Ethernet port
- I/O board
- Power-button board
- System board
- Speakers
- Touchpad
- WWAN I/O board
- Palmrest assembly
- Display bezel
- Display panel
- Camera
- Display cable
- Display back-cover
- Drivers and downloads
- System setup
- Troubleshooting
- Built-in self-test (BIST)
- LCD Built-in Self Test (BIST)
- Dell SupportAssist Pre-boot System Performance Check diagnostics
- Diagnostic LED behavior
- Diagnostic error messages
- System error messages
- Recovering the operating system
- Real-Time Clock (RTC Reset)
- Flashing the BIOS
- Backup media and recovery options
- WiFi power cycle
- Flea power release
- Getting help and contacting Dell
Bienvenue
Bienvenue dans l’univers Dell
Mon compte
- Passer des commandes rapidement et facilement
- Afficher les commandes et suivre l’état de votre expédition
- Profitez de récompenses et de remises réservées aux membres
- Créez et accédez à une liste de vos produits
- Gérer vos sites, vos produits et vos contacts au niveau des produits Dell EMC à l’aide de la rubrique Gestion des informations de l’entreprise.
Latitude 3420 Service Manual
Removing the WWAN card
Prerequisites
- Follow the procedure in before working inside your computer.
- Remove the microSD-card.
- Remove the SIM card tray for 4G LTE enabled systems.
- Enter the service mode.
- Remove the base cover.
About this task
The following image indicates the location of the WWAN card and provides a visual representation of the removal procedure.
NOTE The following steps are applicable only for 4G LTE enabled systems.
Steps
- Remove the screw (M2x3) that secures WWAN card bracket to the WWAN card on the system board.
- Lift and remove the WWAN card bracket from the WWAN card that secures the two antenna cables.
- Disconnect the antenna cables from the connectors on the WWAN card.
- Disconnect and remove the WWAN card from the WWAN card slot.
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez indiquer si l’article a été utile ou non.
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\