- Notes, cautions, and warnings
- Introduction to Dell Command | Configure 4.11.1
- Installing Dell Command | Configure 4.11.1 for systems running on Windows
- Uninstalling Dell Command | Configure 4.11.1 for systems running on Windows
- Upgrading Dell Command | Configure 4.11.1 for computers running on Windows
- Dell Command | Configure 4.11.1 for Windows Preinstallation Environment
- Creating a bootable image preinstallation environment using Windows PE 4.0, 5.0, 10.0, and 11.0
- Integrating the Dell Command | Configure directory structure into an ISO file using Windows PE 11.0
- Integrating the Dell Command | Configure directory structure into an ISO file using Windows PE 10.0
- Integrating the Dell Command | Configure directory structure into an ISO file using Windows PE 5.0
- Integrating the Dell Command | Configure directory structure into an ISO file using Windows PE 4.0
- Creating a bootable image preinstallation environment using Windows PE 2.0 and 3.0
- Creating a bootable image preinstallation environment using Windows PE 4.0, 5.0, 10.0, and 11.0
- References for Dell Command | Configure
Dell Command | Configure Version 4.11.1 Installation Guide
Introduction to Dell Command | Configure 4.11.1
Dell Command | Configure is a software package that provides BIOS configuration capability for Dell client systems. IT can use this tool to configure BIOS settings and create BIOS packages using the Dell Command | Configure User Interface (UI) or Command Line Interface (CLI).
Dell Command | Configure 4.11.1 supports the following Windows operating systems:
- Windows 11
- Windows 10
- Windows Preinstallation Environment (Windows PE)
This guide provides the installation instructions for Dell Command | Configure.
NOTE:This software was rebranded as Dell Command | Configure after Dell Client Configuration Toolkit version 2.2.1.
- Dell Command | Configure 4.10.1 or later generates a 64–bit SCE with constraints.
- On a 64–bit client machine with a WoW64 subsystem, both 32–bit and 64–bit SCE are generated.
- If a WoW64 subsystem is not present in the client system, and then only a 64–bit SCE is generated.
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez attribuer une note (1 à 5 étoiles).
Veuillez indiquer si l’article a été utile ou non.
Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\