Passer au contenu principal
  • Passer des commandes rapidement et facilement
  • Afficher les commandes et suivre l’état de votre expédition
  • Créez et accédez à une liste de vos produits

Dell EMC PowerEdge XE7420 Installation and Service Manual

Removing the fabric processor from the processor heat sink module

Prerequisites

WARNING The heat sink may be hot to touch for some time after the system has been powered off. Allow the heat sink to cool before removing it.
NOTE This procedure is only for replacing a heat sink or a processor. This procedure should not be followed while replacing a system board.
  1. Follow the safety guidelines listed in the Safety instructions.
  2. Follow the procedure listed in the Before working inside your system.
  3. Remove the air shroud.
  4. Remove the processor and heat sink module.

Steps

  1. Place the heat sink with the processor contact side facing up.
  2. Insert the flat blade screwdriver into the release slot and twist (do not pry) the screwdriver to break the seal created by the thermal paste.
  3. Push the retaining clips on the processor bracket to unlock the bracket from the heat sink.
  4. Lift the bracket and the processor away from the heat sink, and place the processor side down on the processor tray.
  5. Flex the outer edges of the bracket close to the fabric connector to release the bracket from the processor.
    Figure 1. Loosening the processor bracket
    Loosening the fabric processor bracket
    Figure 2. Removing the processor bracket
    Removing the fabric processor bracket

Évaluez ce contenu

Précis
Utile
Facile à comprendre
Avez-vous trouvé cet article utile ?
0/3000 characters
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez attribuer une note (1 à 5 étoiles).
  Veuillez indiquer si l’article a été utile ou non.
  Les commentaires ne doivent pas contenir les caractères spéciaux : <>()\