Skip to main content
Sign Out

Welcome to Dell

My Account
  • Place orders quickly and easily
  • View orders and track your shipping status
  • Create and access a list of your products
  • Manage your Dell EMC sites, products, and product-level contacts using Company Administration.
Sign In Create an Account Premier Sign In Partner Program Sign In
Contact Us

Dell PowerEdge M830 (For Dell PowerEdge VRTX Enclosure) Owner's Manual

PDF

Removing an expander card

Prerequisites

CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team. Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions that are shipped with your product.
NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures should be performed only by Dell certified service technicians.
NOTE: You must remove the expander card to replace a faulty expander card.
NOTE: Ensure that you install an expander card if you are using 1.8-inch (x12) system.
  1. Follow the safety guidelines listed in the Safety instructions section.
  2. Follow the procedure listed in the Before working inside your system section.

  3. Keep the #1 and #2 Phillips screwdrivers ready.

  4. Remove the following:

    1. hard drives or SSDs
    2. hard-drive backplane or SSD backplane
    3. hard-drive cage or SSD cage

Steps

  1. Loosen the retention screws on the expander-card cable connector that connects to the connector on the system board (J_PERC) and lift the cable up..
    CAUTION: To prevent damage to an expander card, hold the card only by its edges.
  2. Remove the screws that secure the expander card to the chassis.
  3. Lift the card away from the system.
    Figure 1. Removing an expander card
    This figure shows removing and installing an expander card.
    1. screw (3)
    2. expander-card cable connector that connects to the connector on the system board (J_PERC)
    3. expander card cable
    4. expander card
    5. guide pin (2)

Next steps

  1. Install the expander card.

  2. Follow the procedure listed in the After working inside your system section.

Rate this content

Accurate
Useful
Easy to understand
Was this article helpful?
0/3000 characters
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please provide ratings (1-5 stars).
  Please select whether the article was helpful or not.
  Comments cannot contain these special characters: <>()\