Passa al contenuto principale
  • Effettua gli ordini in modo rapido e semplice
  • Visualizza gli ordini e monitora lo stato della spedizione
  • Crea e accedi a un elenco dei tuoi prodotti
  • Gestisci i siti, i prodotti e i contatti per livello di prodotto di Dell EMC tramite l'amministrazione della società.

OpenManage Integration for Microsoft System Center Version 7.2.1 for System Center Configuration Manager and System Center Virtual Machine Manager Unified User’s Guide

Install and upgrade scenarios in OMIMSSC

This section has all the troubleshooting information related to installing and upgrading OMIMSSC.

Verifying OMIMSSC Appliance VM configuration

To verify that the OMIMSSC Appliance VM is configured appropriately, select and then right-click the OMIMSSC Appliance VM, click Settings, and then perform the following tasks:
  1. Check if the allocation of memory for the OMIMSSC Appliance is as per the requirement mentioned in the Common requirements section of Dell EMC OpenManage Integration for Microsoft System Center Version 7.2.1 for System Center Configuration Manager and System Center Virtual Machine Manager User Guide. Else provide the memory in Startup RAM, and click Apply.
  2. Check if the processor count is as per the requirement mentioned in the Common requirements section of Dell EMC OpenManage Integration for Microsoft System Center Version 7.2.1 for System Center Configuration Manager and System Center Virtual Machine Manager User Guide. Else provide the number of processor counts in Number of Virtual processors count under Processors.
  3. Check if the Virtual hard disk field under IDE Controller: IDE Controller 0 > Hard Drive the Virtual hard disk referring to the OMIMSSC—v7 file else, click Browse and navigate to the location where the VHD file is unzipped and select the OMIMSSC—v7 file and click Apply.
  4. Check if Network Adapter > Virtual Switch is connected to a physical NIC card, else configure the NIC card, and select the appropriate NIC card from the Virtual Switch drop-down menu and click Apply.
If the newly created virtual machine with the selected virtual hard disk of OMIMSSC Appliance fails to boot with any kernel panic exception, edit the virtual machine settings, and enable the dynamic memory option for this virtual machine.To enable the dynamic memory option for a virtual machine, perform the following tasks:
  1. Right-click the OMIMSSC Appliance VM, click Settings, and then click Memory.
  2. Under Dynamic Memory, select the Enable Dynamic Memory check box, and provide the details.

Classifica questo contenuto

Preciso
Utile
Facile da comprendere
Questo articolo ti è stato d'aiuto?
0/3000 characters
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Fornisci una valutazione (1-5 stelle).
  Indica se l'articolo è stato utile o meno.
  I commenti non possono contenere i seguenti caratteri speciali: <>() \