You can set
alerts and actions for certain events that occur on the managed system.
An event occurs when the status of a system component is greater than
the pre-defined condition. If an event matches an event filter and
you have configured this filter to generate an alert (e-mail, SNMP
trap, IPMI alert, remote system logs, or WS events), then an alert
is sent to one or more configured destinations. If the same event
filter is also configured to perform an action (such as reboot, power
cycle, or power off the system), the action is performed. You can
set only one action for each event.
To configure iDRAC7 to send
Optionally, you can filter the alerts based on category
Configure the e-mail alert, IPMI alert, SNMP trap, remote
system log, operating system log, and/or WS-event settings.
Enable event alerts and actions such as:
Send an email alert, IPMI alert, SNMP traps, remote system logs,
operating system log, or WS events to configured destinations.
Perform a reboot, power off, or power cycle the managed system.