You can set the first boot device for the next boot only or for
all subsequent reboots. Based on this selection, you can set the first
boot device for the system. The system boots from the selected device
on the next and subsequent reboots and remains as the first boot device
in the BIOS boot order, until it is changed again either from the
iDRAC7 Web interface or from the BIOS boot sequence. You can set the
first boot device to one of the following:
Local Floppy/Primary Removable Media
Local SD Card
BIOS Boot Manager
BIOS Setup (F2), Lifecycle Controller (F10), BIOS Boot Manager
(F11) only support boot once enabled.
Virtual Console does not support permanent boot configuration.
It is always boot once.
The first boot device setting in iDRAC7 Web Interface overrides
the System BIOS boot settings.