Secure Shell (SSH) and Telnet are network protocols used to perform command line communications to iDRAC7. You can parse remote RACADM and SMCLP commands through either of these interfaces.

SSH has improved security over Telnet. iDRAC7 only supports SSH version 2 with password authentication, and is enabled by default. iDRAC7 supports up to two SSH sessions and two Telnet sessions at a time. It is recommended to use SSH as Telnet is not a secure protocol. You must use Telnet only if you cannot install an SSH client or if your network infrastructure is secure.

Use opensource programs such as PuTTY or OpenSSH that support SSH and Telnet network protocols on a management station to connect to iDRAC7.

NOTE: Run OpenSSH from a VT100 or ANSI terminal emulator on Windows. Running OpenSSH at the Windows command prompt does not result in full functionality (that is, some keys do not respond and no graphics are displayed).

Before using SSH or Telnet to communicate with iDRAC7, make sure to:

Configure BIOS to enable Serial Console.
Configure SOL in iDRAC7.
Enable SSH or Telnet using iDRAC7 Web interface or RACADM.
Telnet (port 23)/ SSH (port 22) client <−−> WAN connection <−−> iDRAC7

The IPMI-based SOL that uses SSH or Telnet protocol eliminates the need for an additional utility because the serial to network translation happens within iDRAC7. The SSH or Telnet console that you use must be able to interpret and respond to the data arriving from the managed systems’s serial port. The serial port usually attaches to a shell that emulates an ANSI- or VT100/VT220–terminal. The serial console is automatically redirected to the SSH or Telnet console.

Related tasks

sol using ipmi protocol

using sol from openssh or telnet on linux

using sol from putty on windows

본 콘텐츠를 평가해주십시오.

정확함

유용함

이해하기 쉬운

이 문서가 도움이 되셨나요?

지원 미지원

이 문서가 문제 해결에 도움이 되었는지 여부를 알려주시기 바랍니다. 피드백 내용을 제출하려면 이 필드를 기입하셔야 합니다.

피드백을 보내 주십시오.

의견에는 <>()\와 같은 특수 문자를 사용할 수 없습니다.

입력한 확인 코드가 일치하지 않습니다. 다시 시도하십시오.

//i.dell.com/das/xa.ashx/global-site-design%20WEB/dbab1f69-52f3-6f4e-1ebb-f8c624d31e17/1/OriginalPng?id=Dell/Product_Images/eSupport/icons/esupport-alert-notice-icon.png

피드백을 보내주셔서 감사합니다.

문의처

프리미어 로그인

Partner Program 로그인

Integrated Dell Remote Access Controller 7 (iDRAC7) Version 1.50.50 User's Guide

SOL Using SSH or Telnet Protocol

본 콘텐츠를 평가해주십시오.

이 문서가 도움이 되셨나요?

피드백을 보내 주십시오.